What Are The Requirements Of The Automatic Locking Screw Machine For Screws?

What are the requirements of the automatic locking screw machine for screws? We know that the application of automatic locking screw machine has been widely used, not only high efficiency, but also relatively low cost, so what are the requirements for screws when using automatic locking screw machine, including screw specifications, length and so on.

The requirements of the automatic locking screw machine for screws are as follows: the total length of the screw must be greater than 1.2mm of the diameter of the screw cap, and the depth of the screw hole should not exceed 40mm. When working, be sure to check whether there are any obstacles within 10mm of the screw hole. , since obstacles must affect operations in consumption. In addition, the surface of the screw hole must be a flat surface or an inclined surface less than 30 degrees.

If the screw has a gasket, and the gasket is larger than the diameter of the screw cap, then the diameter of the gasket should prevail, so that it will not be turned over in the feeding tube. If the total length of the screw does not reach more than 1.2MM of the screw cap, then the feeding method must be adsorption or other methods. The threads of the screws are different. There are triangular self-tapping locking screws, which have different pitches and included angles from metric threads, but the cross-section is a triangle. There are two parameters, D and C, that control the locking. Able to achieve locking function.