Hand-held Push-pull Screw Machine Or Push-down Type Which Is Better

1. Hand-held push-down screw machine

The hand-held push-down screw machine is a widely used screw-driving equipment. Most of the products and situations use the push-down type, which uses the automatic blowing feeding method, the self-locking screw mechanism uses the sliding sleeve mode, and the screws are directly fed. To the clamping nozzle, it is tightened by pressing down, which is light and practical in operation.

2. Hand-held push-pull screw machine

The hand-held push-pull screw machine also uses an air-blowing automatic nail feeding machine. The difference is that the self-locking screw structure uses an independent cylinder to push and pull. The purpose is to reduce the occlusion of the screw by the clamping nozzle. The screwdriver head pushes out the screw and magnetically attracts the screw. The operator can see the position of the screw clearly. The machine is mainly used for deep holes, heterosexual holes, and other components such as electrical appliances around the screw holes. Capacitors and resistors on the circuit board, etc.

In general, it is faster to use the push-down type solution, the actual operation is dexterous, and it is not easy to get tired for a long time, while the push-pull self-locking screw is longer than the push-down type, and the actual operation for a long time will feel fatigue; Directly drive the screw through the clamping nozzle, and the clamping nozzle will block the screw, which is not practical for deep-hole screws and complicated product structures. At this time, the push-pull type is better.