What Should I Do If The Automatic Locking Screw Machine Is Stuck?

The automatic locking screw machine is a frequent occurrence, and the common problem is that the screw surface of the jammed material and the nut become flowery. The automatic locking screw machine problem in the situation will stop, which means that the card will affect the entire production progress, and in serious cases, the screw machine will stop working; first, the small card phenomenon can quickly find the reason and adjust it in time without affecting the production progress.

Reason: Most of the automatic nailing machine cards are caused by the quality of screws, but the problems of these screws are usually caused by flower heads and sliding teeth. There are two reasons; one part is the structural design of the automatic screwing machine. , Another part is due to the channel of the automatic screw-tightening machine, including the electric batch lock and the diameter of the machine head. The manufacturer has classified this point into a new category, which also accelerated the performance of the automatic screw-tightening machine.

Solution: If the screw is broken, just pick out the bad screw to ensure that the screw shape is standardized; but if there is no structural problem, we need to accept the equipment according to our own operating procedures after Cao Cheng is fluent; if If the screw groove is large, it is necessary to ensure the stability of the automatic locking screw machine.